Table of Contents
Advertisement
2.3. INSTALLATION AND USE OF
ACCESSORIES
2.3.1. 7/8" WEAVER MOUNT
Optional Weaver mount can be used to install the PS-40 on a MIL-
STD-1913 rail if mounting rail on the rifle has narrow groves (4 mm).
Nut
Clamp bar
Figure 2-7. Assembling PS-40 with Weaver Mount
A. Loosen and remove two screws (M4x8) which secure the
quick release mount to the sight body. Remove the mount.
B. Put the Weaver mount onto the lug on the sight body. The
nuts of the mount have to be placed on the same side as
the switch knob. Apply a small amount of thread locker on
threads, install two screws (M4x8) and tighten it.
C. Loosen the mount nuts and pull the clamp bar back against
the nuts.
D. Place the sight onto the rail surface. Be sure to engage the
mount studs into the grooves on the top mounting surface
of the rifle. The light suppressor should cover the riflescope
objective lens.
F. Tighten the nuts using screwdriver.
Weaver mount
M4x8 Screw
2-11
Advertisement
Table of Contents
