Table of Contents
Advertisement
Dayscope objective lens
Figure 2-5. PS-40 Installed on Dayscope Objective Lens
Install the PS-40 on dayscope objective lens as follows:
A. Loosen and remove two mounting screws M4x8 the quick
release mount, remove the mount and put it into the storage
case.
B. Take off the output lens cap and put it into the storage case.
C. Insert the output lens into the scope mounting system and
place the rail of the mounting system where the quick release
miount was above the battery compartment of the sight.
D. Apply a small amount of thread locker on threads, install two
screws M4x8 and tighten it.
E. Loosen the nut of the mounting system.
F. Slide the PS-40 with mounting system onto the objective lens
of dayscope up to the stop.
G. To complete the installation of the mounting system to your
dayscope, use a screw driver to tighten the nut of the mounting
system. Do not apply excessive torque.
2-6
M4x8 Screw
Fixing nut
Rail for IR 450
Scope Mounting System
Insert
Advertisement
Table of Contents
