Installation On Dayscope Objective Lens - ATN PS-40 Operator's Manual

B. Remove the light suppressor from the storage case. Put it on in
place of the out put lens cap.
C. To open the sight quick release mount , slide the cam latch for-
ward (arrow A, Figure 2-4) and turn the cam backward (arrow B).
D. Place the sight onto MIL-STD-1913 rail. Be sure to engage the
recoil lug into the groove on the top mounting surface of the
rifle. The light suppressor should cover the riflescope objective
lens.
F. Turn the cam forward pushing the latch to close the mount.
G. The quick release mount may be adjusted to eliminate ex-
cessive play when mounted on the rail by using the provided
wrench (see figure 1-1) to increase/decrease the cam latch
nut. (see figure 2-4)
CLOSED POSITION
B
2.1.3. INSTALLATION ON DAYSCOPE OBJECTIVE
LENS
Presented in Table 2-1 optional scope mounting systems are de-
signed to install the PS-40 on riflescope/sporting scope objective
lens. The systems are equipped with a rail for mounting optional IR
illuminator.
CAUTION
The PS-40 can not be attached to the riflescope/sporting scope
that have a focusing ring on the objective lens housing.
2-4
OPENED POSITION
A
Cam
Latch
Cam
Figure 2-4. quick Release Mount
CAM ADJUSTMENT
Cam Latch Nut
Wrench