Slt On-Hook Operation Mode - Panasonic KX-T336 Installation Instructions Manual

(4) SLT On-hook Operation Mode

In single line telephone procedures, active call is put on consultation hold
when the switchhook is pressed down for approximately
released.
In this case, consultation hold recall tone will ring immediately if you replace
the handset on the switchhook without dialing any digits.
Then you may hear recorder tone when you lift the handset to reply this
ringing
This, may happen sometimes if the handset is replaced on the switchhook
after hopping on it.
To prevent such unexpected consultation hold tone from ringing, select
for this setting.
When setting "Y is selected,
a call put consultation hold will be disconnected if you replace the handset
on the switchhook without dialing any digits.
When '1 I is selected. - default
(1)
Talking
Talking with a
caller.
When "Y is selected
(1) Talking
Talking with a
caller.
(Note)
To hang up and make another call right away, an SLT user should
hold down the switchhook for more than two seconds.
(Parameters)
1 : Hang-up causes ringing of consultation hold recall tone. (default)
2 : Hang-up disconnects a call on consultation hold.
Technical Manuals Online! - http://www.tech-man.com
(3) On-hook
(2) Hooking
A call is put on
any digits.
consultation
hold.
(3) On-hook
(2) Hooking
Without dialing
any digits.
consultation
hold.
10-C-82
(30393)
. .
(4)
Recall
Consultation hold
tone rings.
(4) Disconnection
A call on
consultation hold
is
be sure to