World Select 2 (Vvs2) - Panasonic KX-T336 Installation Instructions Manual

52.00 World Select 2 (VVS2)

Description
command provides the following assignments.
(Password level: Two or higher)
(1) First Dial Timer
On outgoing CO calls, the system waits at least 0.5 seconds after seizing
the CO line, before sending the dialing digits required by the central office.
This allows the central office enough time to accept the dialing digits
correctly. Default setting is 1 .O second and can be ranged from 0.5 to 8.0
seconds.
(2) First Dial Timer (DID)
Available when "Type" of a Trunk Group is set to "DID" or "TIE".
(3) EQU Access
Used to activate or deactivate the EQU Access feature on a system-wide
basis. If "N" is selected by this command, programming screen of "Special
Carrier Access" Equal Access is not accessible.
(4) OCC Access
Used to activate or deactivate the OCC Access feature on a system-wide
basis. If "N" is selected by this command, programming screen of 'Special
Carrier Access" OCC Access is not accessible.
(5) Outgoing CO Back Tone
On outgoing CO calls, dialed number is toned out, which informs the
extension users that dialed number has been dialed.
CO Dialing Tone is usually toned out by default setting, select
the CO dialing tone.
(6) L-COT Busy Out Looprelay,
When CO line is busied out either manually by the operator or automatically
by the system, the state of Loop Relay is controlled by this setting.
(7) G-COT Busy Out Looprelay
When CO line is busied out either manually by the Operator 1, or
automatically by the system, the state of Loop Relay and Ring-FG are
controlled by this setting.
Input Format
Index Number
None
Technical Manuals Online! - http://www.tech-man.com
1 o-c-79
(70695)M