MR-8HD/CD
Owner's Manual (Advanced playback and locate functions)
By holding down the [F FWD] or [REWIND] key during playback, the recorder enters cueing mode
and you can monitor playback at 3 x speed. It may be useful for searching a specific position.
[REWIND] key
RECORD
STOP
LOCATE REC END
LOCATE ABS ZERO
A-B PLAY
Playback between LOCATE A and B points
When the LOCATE A and LOCATE B points are set, you can playback between these points once.
This function is always available regardless of the play mode setting (see "Play mode" on next
page). This function allows you to check the editing part (between LOCATE A and B points) for
copy/paste, erase, etc. See "Part editing" described later.
[STOP] key
RECORD
STOP
LOCATE REC END
LOCATE ABS ZERO
A-B PLAY
<Note>:
Note that this function is available only
when the LOCATE A and B points are set.
See page 49 for details about how to set the LO-
CATE A and B points.
If you carry out the operation above when
<Note>:
the LOCATE A point is set ahead of the LOCATE B
point (i.e. LOCATE A > LOCATE B), the MR-8HD/
CD plays back audio data from the LOCATE A
point to the REC END points once, then stops.
3 x cueing
[F FWD] key
PLAY
REWIND
F FWD
[PLAY] key
PLAY
REWIND
F FWD
•
By holding down the [F FWD] key during play
back, the recorder starts cueing forwards at 3 x
speed.
During forward cueing, ">>" is shown on the
display.
•
By holding down the [REWIND] key during play
back, the recorder starts cueing backwards at 3
x speed.
During backward cueing, "<<" is shown on the
display.
•
While the recorder is stopped, press the [PLAY]
key while holding down the [STOP] key.
The MR-8HD/CD plays back audio data
between the LOCATE A and LOCATE B points
once, then stops.
LOCATE A point
While the recorder is playing back between the
LOCATE A and B points, the display shows the
icon as below.
During playback, you can monitor playback
audio of the desired track(s) by raising the ap-
propriate track fader(s), the [MASTER] fader
and the [PHONES] control.
44
LOCATE B point
Playback