Setting The System Date And Time; Sending System Reset Commands; About Option; Help Option - AMX WebLinx Instruction Manual

Administrator Operations

Setting the system date and time

The Set Date/Time command sets the linked Central Controller's date and time.
1. Click Diagnostics on the main page.
2. Click Set Date/Time to open the Set Date/Time page. Enter the month, day, and year in the
Date fields. Then, enter the hour, minute and seconds in the Time field.
3. Click Set Clock to reset the date and time. Then, click Back to Main.

Sending system reset commands

The System Reset command resets the Central Controller's master processor, and then runs the
Startup Code (DEFINE_START) portion of the Axcess program installed in the master processor.
This command should only be used after all Axcess network wiring/connections are checked, and
the problem cannot be resolved.
Do not use the System Reset command unless all control functionality stops. Before
sending the System Reset command, check all network and Central Controller
connections for electrical shorts, improper wiring, and/or bad connectors.
1. Click Diagnostics on the main page.
2. Click System Reset to reset the linked Central Controller. When the reset is complete, click
Back to Main.

About Option

You can open the About page to see the Administrator program's version, build number, and release
date.
1. Click About on the main page.
2. Click anywhere on the About page to close it.

Help Option

Click Help to launch the WebLinx Help program. If a File Download dialog box opens, click the
Open this file from its current location option. Then, disable the Always ask before opening this
type of file option.
28 WebLinx Administrator Program