Setting The System Value - AMX AXT-CA10 Instruction Manual

9. Click on the OnLine Tree tab in the Workspace window to view the devices on the System.
The default System value is one.
10. Right-click on the Empty Device Tree entry and select Refresh System to establish a new
connection to the System's Master and refresh the list with online system devices. The
communication method is highlighted in green on the bottom of the NetLinx Studio window.

Setting the System Value

1. Access/open the Device Addressing dialog box (FIG. 2) by either one of these two methods:
System Address
(default for initial
system is 1)
Check-Off to
verify change
FIG. 2 Device Addressing tab (changing the system value)
This tab represents the only way to change the System Number. The Master must be
rebooted to incorporate the new System number.
2. Select the Change System selection box from the System to Change section.
3. Enter both the current and new system address values (this example uses 2).
4. Click the Change Device/System Number button. This configures the Master to accept the
new value and incorporate the information. The system information (in the OnLine Tree tab of
the Workspace window) refreshes and then displays the new information.
5. Click Done to close the Device Addressing dialog and return to the main program.
6. Click Reboot (from the Tools > Reboot the Master Controller dialog) and wait for the System
Master to reboot. The STATUS and OUTPUT LEDs should begin to alternately blink during
the incorporation. Wait until the STATUS LED is the only LED to blink.
7. Press Done once the Master Reboot Status field reads Reboot of System Complete.
8. Click the OnLine Tree tab in the Workspace window to view the devices on the System. The
default System value is one (1).
9. Right-click associated System number and select Refresh System. This establishes a new
connection to the specified System and populates the list with devices on that system.
DXP-PRO v1.1 - On-Site Installer's Guide
Right-click on any System item listed in the OnLine Tree tab of the Workspace and
select Device Addressing (from the pop-up list).
Select Diagnostics > Device Addressing from the Main menu.
Using NetLinx Studio
19