Note
The touch panel must always
be installed with the release
slot located at the bottom.
Figure 8
AXU-CP and BB-TP2
UniMount enclosure
(plasterboard)
10
Installing the Touch Panel
Thread the incoming AXlink and RS-232 wiring through the BB-TP2 knockout.
8.
Fasten the BB-TP2 to the solid surface with the mounting screws supplied with
9.
the enclosure.
Connect the AXlink and RS-232 wiring to the touch panel. (Refer to Wiring the
10.
Touch Panel for complete wiring information.)
Fasten the touch panel to the BB-TP2 with the #6-32 screws provided with the
11.
enclosure.
Insert the engraved overlay back into the bezel.
12.
Connect the AXlink wiring to the AMX Control System and RS-232 wiring to the
13.
external RS-232 device. The touch panel will beep when you apply power.
AXU-CP or AXU-CP/PB, and BB-TP2 (plasterboard)
Mount the AXU-CP or AXU-CP/PB, and BB-TP2 ( Figure 8) into a plasterboard
surface (or equivalent):
BB-TP2 UniMount enclosure
Stud mounting
holes
Plasterboard surface
mounting flanges
Knockout
Expansion clips
AXU-CP bezel
Release slot
Engraved overlay
Color Passive-Matrix LCD Touch Panels