HP 53131A/132A 225 MHz Programming Manual page 62

Keyword/Syntax Parameter Form
[:SENSe] (Cont.)
:TINTerval
:ARM
:ESTART
:LAYer2
POSitive | NEGative
:SLOPe
IMMediate | EXTernal
:SOURce
[:LAYer[1]]
<numeric_value>
:ECOunt
:SOURce IMMediate | TIMer |
INTernal1
<numeric_value>
:TIMer
:ESTOP
:LAYer2
POSitive | NEGative
:SLOPe
IMMediate | EXTernal
:SOURce
[:LAYer[1]]
<numeric_value>
:ECOunt
Chapter 2 Command Summary
HP 53131A/132A Command Summary
Table 2-2A. HP 53132A (S/N Prefix 3646 and Above) Time Interval
Arming SCPI Command Summary
2-38
Std/ Comments
New
New Subtree. Controls the time interval (including
Time Interval, Rise Time, Fall Time, Dutycycle,
and Pulse Width functions) measuring
capabilities of the instrument.
New Subtree. Synchronizes the time interval start and
stop arm with events.
New
New
New Sets the slope of the external start arm signal
used in external arming Time Interval
measurements (including Time Interval, Rise
Time, Fall Time, Dutycycle, and Pulse Width).
New Sets the start arm for time interval (including
Time Interval, Rise Time, Fall Time, Dutycycle,
and Pulse Width) measurements.
New
New Sets the event count used to delay the start arm
for Time Interval measurements. Only applies
when [:SENS]:TINT:ARM:ESTART:SOUR INT1
is selected.
New Sets the start arm delay for Time Interval
measurements.
New Sets the time used to delay the start arm for
Time Interval measurements. Only applies when
[:SENS]:TINT:ARM:ESTART:SOUR TIM is
selected.
New
New
New Sets the slope of the external stop arm signal
used in external arming Time Interval
measurements.
New Sets the stop arm for Time Interval
measurements.
New
New Sets the event count used to delay the stop arm
for Time Interval measurements. Only applies
when [:SENS]:TINT:ARM:ESTOP:SOUR INT2 is
selected.
Programming Guide