HP 53131A/132A 225 MHz Programming Manual page 55

<function> *
[:VOLTage]:DCYCle
or
[:VOLTage]:PDUTycycle
[:VOLTage]:FALL:TIME
or
[:VOLTage]:FTIMe
[:VOLTage]:FREQuency
[:VOLTage]:FREQuency:RATio
[:VOLTage]:MAXimum
[:VOLTage]:MINimum
[:VOLTage]:NWIDth
[:VOLTage]:PERiod
[:VOLTage]:PHASe
[:VOLTage]:PTPeak
[:VOLTage]:PWIDth
[:VOLTage]:RISE:TIME
or
[:VOLTage]:RTIMe
[:VOLTage]:TINTerval
[:VOLTage]:TOTalize:CONTinuous
[:VOLTage]:TOTalize:TIMed
Chapter 2 Command Summary
Front Panel to SCPI Command Maps
Table 2-2. HP 53131A/132A SCPI Command Summary (Continued)
<parameters>
[<reference>]
[<reference>]
[<lower_reference>[,upper_reference>]
]
[<lower_reference>[,upper_reference>]
]
***
[<expected_value>[,<resolution>]]
[<expected_value>[,<resolution>]]
[<reference>]
[<expected_value>[,<resolution>]]
[<reference>]
[<lower_reference>[,upper_reference>]
]
[<lower_reference>[,upper_reference>]
]
****
[<gate_time>]
______________________________
*
The only functions which can be derived (using FETC? or READ?) from the stored data are period
to/from frequency, maximum to/from minimum, maximum to/from peak-to-peak, and minimum
to/from peak-to-peak. All other functions require an acquisition of a new type.
**
<source_list> has the same syntax as SCPI <channel _list> syntax. For example, a
single-channel function (e.g., frequency, period, etc.) would use (@1) to specify channel 1,
whereas a two-channel function (e.g., time interval, phase, and frequency ratio) would use (@1),
(@2) to specify a measurement between channel 1 and channel 2.
***
For HP 53131A firmware revision s below 3335, only Ratio 1 to 2 and Ratio 1 to 3 were offered .
****
This <function> is only allowed with :CONFigure.
Programming Guide
[,<source_list>] **
[ (@1) ]
[ (@1) ]
[ (@1) ]
[ (@1) ]
[ (@1) | (@2) | (@3)
]
[ (@1), (@2 | @3) |
(@2 | @3), (@1) ]
[ (@1) | (@2) ]
[ (@1) | (@2) ]
[ (@1) ]
[ (@1) | (@2) | (@3)
]
[ (@1), (@2) ]
[ (@1) | (@2) ]
[ (@1) ]
[ (@1) ]
[ (@1) ]
[ (@1), (@2) ]
[ (@1) ]
[ (@1) ]
2-31
Std/
New
Std
Std
Std
Std
Std
New
Std
Std
Std
Std
Std
Std
Std
Std
Std
New
New
New