HP 53131A/132A 225 MHz Programming Manual page 53

Keyword/Syntax Parameter Form
:INITiate
<Boolean>
:AUTO
<Boolean>
:CONTinuous
[:IMMediate]
:INPut[1|2]
1 | 10
:ATTenuation
AC | DC
:COUPling
:FILTer
[:LPASs]
<Boolean>
[:STATe]
:FREQuency?
<numeric_value>
:IMPedance
[OHM]
:INPut3
:COUPling?
:IMPedance?
:MEASure
Chapter 2 Command Summary
Front Panel to SCPI Command Maps
Table 2-2. HP 53131A/132A SCPI Command Summary (Continued)
Std/
New
Std
New
Std
Std
Std
Std
Std
Std
Std
Std
Std
Std
Std
Std
Std
Std
Programming Guide
Comments
Subsystem. Controls the initiation of measurements.
AUTO ON enables the Counter to automatically stop
measuring on a limit test failure. AUTO OFF
disables the automatic stop.
Sets the enable for continuously initiated
measurements.
Event; no query. Causes the instrument to initiate
the number of measurements specified by
:TRIGger:COUNt:AUTO.
Subsystem. Controls the characteristics
of the instrument ' s input ports. :INPut1= channel 1
and :INPut2= channel 2
Sets input attenuation.
Sets input coupling.
Subtree. Allows a low pass filter to be inserted in the
path of the measurement signal.
Subtree. Controls the Low PASs filter.
Sets the Low PASs filter enable.
Query only. Returns the cutoff frequency of the low
pass filter. Units are Hertz.
Sets input impedance (50
Subsystem. Queries the characteristics of the
Counter' s input channel 3.
Query only. Returns channel 3 input coupling.
Query only. Returns channel 3 input impedance.
See Measurement Instructions in this table.
or 1 M ).
2-29