HP 53131A/132A 225 MHz Programming Manual page 59

Keyword/Syntax
[:SENSe] (Cont.)
:ROSCillator (Cont.)
:SOURce
:AUTO
:TINTerval
:ARM (HP 53131A
and HP 53132A with
S/N prefix below
3646)
[:STARt]
:SLOPe
:SOURce
:STOP
:SOURce
:TIMer
:TOTalize
:ARM
[:STARt]
:SLOPe
:SOURce
Chapter 2 Command Summary
Front Panel to SCPI Command Maps
Table 2-2. HP 53131A/132A SCPI Command Summary (Continued)
Parameter Form
INTernal | EXTernal
<Boolean>
See Table 2-2A on
page 2-38 for HP
53132A (with S/N
3646 and above )
TINTerval
ARM commands)
POSitive | NEGative
IMMediate | EXTernal
IMMediate | TIMer
<numeric_value> [S]
POSitive | NEGative
EXTernal | IMMediate
Programming Guide
Std/ Comments
New
Std Sets the selection of a reference timebase.
Std Sets the enable for automatically selecting a reference
timebase.
New Subtree. Controls the time interval (including Time
Interval, Rise Time, Fall Time, Dutycycle, and Pulse
Width functions) measuring capabilities of the
New instrument.
Subtree. Synchronizes the time interval start and stop
arm with events.
New
New Subtree.
Sets the slope of the external start arm signal used in
external arming time interval measurements (including
Time Interval, Rise Time, Fall Time, Dutycycle, and
Pulse Width functions). Only applies when
New [:SENS]:TINT:ARM[:STAR]:SOUR EXT is selected.
Sets the start arm for time interval (including Time
Interval, Rise Time, Fall Time, Dutycycle, and Pulse
New Width) measurements.
New Subtree.
Sets the stop arm (i.e., the delay) for Time Interval
New measurements.
Sets the time used to delay the stop arm for Time
Interval measurements. Only applies when
New [:SENS]:TINT:ARM:STOP:SOUR TIM is selected.
Subtree. Controls the totalize measuring capabilities of
New the instrument.
Subtree. Synchronizes totalize start and stop arm with
New events.
New Subtree.
Sets the slope of the external start arm signal used in
external arming totalize measurements. Only applies
New when [:SENS]:TOT:ARM[:STAR]:SOUR EXT is selected.
Sets the start arm for totalize measurements.
2-35