ADTRAN T3SU 300 User Manual page 66

Chapter 3. Configuration
Idle Timeout
Once a call is established and the trap messages are sent, the
T3SU 300 remains online for the amount of seconds entered in this
field. If the field is set to 0, the unit hangs up as soon as the trap is
sent.
Connection Timeout
The T3SU 300 waits for a connection the amount of seconds entered
in this field. Timing begins as soon as the dial command is issued.
Pause Between Calls
The T3SU 300 waits the number of seconds entered in this field
between redial attempts.
Dialout On Trap
Enable or disable the T3SU 300's ability to dial out to report traps.
When configured for D
conditions in plain ASCII with the following information:
•
•
•
When the M
SLIP , the unit logs in to the PPP/SLIP host and reports the error
conditions to the hosts designated under the T
(also found under S
Answer on Ring
Enable or disable the T3SU 300's ability to accept an incoming call.
If enabled, incoming calls are automatically answered by the
T3SU 300, allowing you to remotely perform management
functions.
Hangup
Selecting this option forces the T3SU 300 to end an established call.
66
IALUP
The Unit ID value programmed in the Unit ID field of the
S M
YSTEM ANAGEMENT
A trap code indicating the error condition (selected from the
screen under S
T G
RAP ENERATION
The date and time when the error was logged
M
ODEM ODE
YSTEM
T3SU 300 User Manual
VT100 , the unit reports error
screen (see Figure 3-9 on page 57).
M
YSTEM
is configured for D
IALUP
M ).
ANAGEMENT
)
ANAGEMENT
PPP or D
IALUP
IP A
RAP DDRESSES
61202217L1-1B