Figure 3-4: Interface Panel Showing Calibration Switch Position; Figure 3-5: H2/Co2 Trim Pot - Teledyne 2750 Operating Instructions Manual

Installation

Figure 3-4: Interface Panel Showing Calibration Switch Position

7. Use the air/CO
Figure 3-4 above.
8. Move the calibration switch to the H2/CO2 position and verify
that the range selector switch is on H2/CO2. Use the H2/CO2
zero trim pot to adjust the display to zero. See Figure 3-5
Teledyne Analytical Instruments
zero trim pot to adjust the display to zero. See
2

Figure 3-5: H2/CO2 Trim Pot

Model 2750
24