Image Projection; Basic Procedure - Sharp XV-Z10000 Operation Manual

Image Projection

Basic Procedure

Connect the required external equipment to
the projector before operating the following
procedures.
Info
The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 34.
1
Plug the power cord into the
wall outlet.
The power indicator illuminates red, and
the projector enters standby mode.
ON
2
Press on the remote con-
trol or on the projector.
The power indicator illuminates blue.
After the lamp replacement indicator il-
luminates, the projector is ready to start
operation.
Note
The lamp replacement indicator il-
luminates, indicating the status of the
lamp.
Blue: The lamp is ready.
Blue blinking: The lamp is
Red: The lamp should be replaced.
If the power is turned off and imme-
diately switched on again, the lamp
replacement indicator may take time
to illuminate.
When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds
after the power has been turned on,
and then transmit the commands.
-32
warming up.
", ',\, | buttons
ENTER
button
Power (OFF)
button
ENTER
button
Power indicator
Lamp replacement
indicator
MENU button
INPUT
button
Power (OFF)
button
Power (ON)
button
Power (ON)
button
MENU button
', ", \, |
buttons
INPUT
buttons