Image Projection; Basic Procedure - Sharp PG-C45XU Operation Manual

Image Projection

Basic Procedure

Connect the required external equipment to the pro-
jector before operating the following procedures.
Info
• The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 36.
1
Plug the power cord into the
wall outlet.
• The power indicator illuminates red, and
the projector enters standby mode.
ON
2
Press on the projector or on
the remote control.
• The power indicator illuminates green.
After the lamp replacement indicator il-
luminates, the projector is ready to start
operation.
Note
• The lamp replacement indicator il-
luminates, indicating the status of the
lamp.
Green: The lamp is ready.
Green blinking: The lamp is
Red: The lamp should be replaced.
• If the power is turned off and immediately
switched on again, the lamp replacement
indicator may take time to illuminate.
• When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds
after the power has been turned on,
and then transmit the commands.
When "Anti-Theft" (see page 75) is set,
the keycode input box will appear.
• Enter the keycode.
Note
• When entering the keycode, press
the buttons previously set on the
projector or the remote control.
Info
• When "Anti-Theft" is set, enter the
keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (see page 75.)
-34
replacement
Power (ON)
Power (OFF)
warming up.
Power
indicator
Lamp
indicator
button
button
ENTER
button
Power (OFF)
button
ENTER
button
MKeycode input box
INPUT
button
',", \, |
buttons
MENU
button
Power (ON)
button
MENU button
', ", \, |
buttons
INPUT
buttons