Image Projection - Sharp XV-Z12000 Operation Manual

Image Projection

Basic Procedure
Connect the required external equipment to
the projector before operating the following
procedures.
Info
• The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 36.
1
Plug the power cord into the
wall outlet.
• The power indicator illuminates red, and
the projector enters standby mode.
2
Press on the remote control
or on the projector.
• The power indicator illuminates blue.
After the lamp indicator illuminates, the
projector is ready to start operation.
Note
• The lamp indicator illuminates, indi-
cating the status of the lamp.
Blue: The lamp is ready.
Blue blinking: The lamp is
Red: The lamp should be replaced.
• If the projector is put into the
standby mode and immediately
turned on again, the lamp indicator
may take some time to illuminate.
• When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds
after the power has been turned on,
and then transmit the commands.
-34
Downloaded from ProjectorsManual.com Manuals
", ',\, | buttons
ENTER
button
warming up.
STANDBY
button
ENTER
button
Power indicator
Lamp indicator
MENU button
INPUT
button
STANDBY
button
ON button
ON button
MENU button
", ', \, |
buttons
INPUT
buttons