Connecting The Projector To A Computer - Sharp XV-Z10000 Operation Manual

Connecting the Projector to a Computer

Connecting to a Computer
Using the DVI to 15-pin
D-sub Adaptor and the
RGB Cable
Connect the projector to the com-
puter using the DVI to 15-pin D-sub
adaptor and the RGB cable.
Secure the connectors by tightening the
thumbscrews.
Note
See page 84 "Computer Compatibility
Chart" for a list of computer signals
compatible with the projector. Use with
computer signals other than those listed
may cause some of the functions not to
work.
When connecting the projector to a com-
puter in this way, select "A.RGB" for "Sig-
nal Type" in the "Options" menu, or select
the "A.RGB" by pressing
mote control. See page 65.
A Macintosh adaptor may be required for
use with some Macintosh computers.
Contact your nearest Sharp Authorised
Projector Dealer or Service Centre.
Depending on the computer you are us-
ing, an image may not be projected un-
less the signal output setting of the com-
puter is switched to the external output.
Refer to the computer operation manual
for switching the computer signal output
settings.
Supplied
accessory
DVI to 15-pin D-sub adaptor
on the re-
DVI to 15-pin D-sub adaptor
To RGB output terminal
RGB Cable (commercially
available)
Notebook computer
-21