Sharp XV-Z10000 Operation Manual page 36

3
Press , ,
on the remote control or
the projector to select the IN-
PUT mode.
After pressing once on the projector,
use to select the desired input mode.
Note
When no signal is received, "NO
SIGNAL" will be displayed. When a
signal that the projector is not pre-
set to receive is received, "NOT
REG." will be displayed.
The INPUT mode is not displayed
when "OSD display" is set to "Level
A" or "Level B". (See page 64.)
About the INPUT modes
INPUT 1 Used for projecting images
INPUT 2 from equipment that sends
(Compo- component signals or RGB
nent/RGB*) signals connected to the
INPUT 1 or 2 terminals.
INPUT 3 Used for projecting im-
(S-Video) ages from equipment con-
nected to the S-VIDEO in-
put terminal.
INPUT 4 Used for projecting im-
(Video) ages from equipment
connected to the VIDEO
input terminal.
Used for projecting im-
INPUT 5
ages from equipment
(Digital PC
connected to the DVI in-
RGB/
put terminal.
Digital PC
Component/
Digital Video
RGB/Digital
Video
Component/
Analog RGB/
Analog
Component)
* Input the RGB signal of the DTV, not
the computer.
, or
on
"On-screen Display (Example)
INPUT 1 mode
Using RGB*
Using
Component
INPUT 2 mode
Using RGB*
Using
Component
INPUT 3 mode
Using S-Video
INPUT 4 mode
Using Video
INPUT 5 mode
Using Analog
RGB
The display varies accord-
ing to the "Signal Type" with
the INPUT 5. The diagram
shown above is the ex-
ample of having selected
"Analog RGB".
-33