Image Projection; Basic Procedure - Sharp PG-A10X Operation Manual

Image Projection

Basic Procedure

Connect the required external equipment to the pro-
jector before carrying out the following procedures.
Info
• The language preset at the factory is English.
If you want to change the on-screen display to
another language, reset the language accord-
ing to the procedure on page 28.
1
Plug the power cord into the wall
outlet.
• The power indicator illuminates red, and
the projector enters standby mode.
2
Press
on the remote control.
• The power indicator illuminates green.
After the lamp replacement indicator illu-
minates and the warming up message
on the display disappears, the projector
is ready to start operation.
Note
• The lamp replacement indicator illumi-
nates, indicating the status of the lamp.
Green: The lamp is ready.
Blinking in green: The lamp is warming
Red: The lamp should be replaced.
• If the power is turned off and immedi-
ately switched on again, the lamp re-
placement indicator may take some
time to illuminate.
• When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds af-
ter the power has been turned on, and
then transmit the commands.
• The projector cannot be operated while
the warming up message is displayed.
• When "Anti-Theft" (see page 48) is set,
the keycode input box will appear. Enter
the keycode.
Note
• When entering the keycode, press the
buttons previously set on the projec-
tor or the remote control.
• For details about the Anti-Theft func-
tion, refer to "Anti-Theft (Setting the
Anti-Theft)" on page 48.
-26
Downloaded from: http://www.usersmanualguide.com/
on the projector or
up and shutting down.
Power
indicator
Power ON
button
Power OFF
button
▼Warming up message
Volume
buttons
▼Keycode input box ▼Keycode input box
Lamp
replacement
indicator
INPUT
button
Volume
buttons
Power ON
button
AV MUTE button
INPUT buttons