Loop Playback - Korg Krome Operation Manual

Creating songs (Sequencer mode)
Exclusive Solo
Exclusive Solo is a function that limits the Solo
function (described above) to a single track at a time. If
Exclusive Solo is on, only the track for which Solo was
last turned on will be played; other tracks will always
be silent.
Use the Exclusive Solo menu command to specify how
the Solo function will function.
Exclusive Solo off: You will be able to solo more than
one track at a time. The status of a track will change
each time you press its Solo On/Off button.
Exclusive Solo on: When you press a Solo On/Off
button, only that track will be soloed.
Tip: You can turn Exclusive Solo on/off by holding
down the ENTER button and pressing numeric key 1.

Loop playback

When recording or playing back a song, you can loop
individual tracks that are playing.
In the P0–1: Play Loop T01–08 or T09–16 page, check
Track Play Loop for the tracks you want to loop, and
use Loop Start Measure and Loop End Measure to
specify the starting and ending measure of the region
that will play back as a loop.
If you check Play Intro, the measures preceding the
loop will be played back as an introduction before the
loop begins.
Track Play Loop
Loop Start
Measure
Loop End
Measure
Play Intro
If you play back from the first measure with the
settings shown in the screenshot above, the specified
region of measures will repeat as follows.
Measures 1 2 3
Track 1 1 2 3
Track 2 9 10 9 10 9 10 9 10 9 10 9 10 9
If Play Intro is unchecked, the specified region of
measures will repeat as follows.
Measures 1 2 3
Track 1 5 6 7
Track 2 9 10 9 10 9 10 9 10 9 10 9 10 9
56
4 5 6 7 8 9 10 11 12 13
4 5 6 7 8 5 6 7
4 5 6 7 8 9 10 11 12 13
8 5 6 7 8 5 6 7
8 5
8 5