Korg Krome Operation Manual page 135

File unavailable
Meaning: You attempted to load or open a file whose
format was incorrect.
File/path not found
Meaning: When executing the Delete command in the
Media mode Utility page, the specified file did not
exist.
Meaning: When executing the Copy command in the
Media mode Utility page, and you used a wild card to
specify the copy file name, the specified file was not
found. Alternatively, the length of the copy source path
name exceeded 76 characters.
Meaning: In Media mode when you used the Open
button to open a directory, the path length including
the selected directory name exceeded 76 characters.
• Check the file or directory.
Meaning: When you pressed the WRITE button to save
your data in Sequencer mode, the media was not in a
state that allowed saving, or the previously‐opened
directory was not a location where SNG files could be
saved.
• If the save‐destination directory is something other
than the DOS directory from which you opened a
.PCG or .SNG file, a message such as "File/path not
found" will appear, and the data cannot be saved.
In this case, move to Media mode, select an
appropriate save‐destination, and then execute
Save All or Save SEQ.
I
Illegal file description
Meaning: The filename that you specified when saving
a file or creating a directory contained invalid
characters. To solve this problem:
• Change the filename you are specifying. Filenames
not permitted by MS‐DOS cannot be used as a
filename.
Illegal SMF data
Meaning: You attempted to load a file that was not a
Standard MIDI File.
Illegal SMF division
Meaning: You attempted to load a Standard MIDI File
that was timecode‐based.
Illegal SMF format
Meaning: You attempted to load a Standard MIDI File
of a format other than 0 or 1.
M
Master Track can't be recorded alone
Meaning: When realtime‐recording a single track, you
attempted to begin recording with the master track as
the current track.
• Select a MIDI track for recording, instead of the
Master Track.
Error messages Error and confirmation messages
Measure number over limit
Meaning: The attempted edit procedure would cause
the track length to exceed 999 measures.
• Delete unnecessary measures.
Measure size over limit
Meaning: When loading a Standard MIDI File, the
number of events in a measure exceeded the maximum
(approximately 65,535 events).
Meaning: The attempted edit procedure would cause
the maximum number of events in a measure
(approximately 65,535) to be exceeded.
To solve either of these problems:
• Use event editing etc. to delete unwanted data.
Media changed
Meaning: When executing the Copy command in the
Media mode Utility page, the media was exchanged or
ejected, and it was not possible to copy between
separate media on the same drive.
Media unavailable
Meaning: You selected a media source that does not
allow writing.
Media write protected
Meaning: The other writing‐destination media is
write‐protected.
• Turn off write protect on the other media, and
execute the command once again.
Memory full
Meaning: When editing a song, track or pattern in
Sequencer mode, the total data of all songs has used up
all of the sequence data memory, and further editing is
not possible. To solve this problem:
• Delete other song data etc. to regain free memory.
Meaning: While realtime recording in Sequencer
mode, there is no more free memory to accommodate
the recorded data, so recording has been forcibly
halted. To solve this problem:
• Delete other song data etc. to regain the amount of
free memory.
Memory overflow
Meaning: While receiving exclusive data in Media
mode Save Exclusive, all remaining internal memory
was used up. To solve this problem:
• If you are receiving two or more sets of exclusive
data, transmit them separately to the KROME.
Memory Protected
Meaning: The internal program, combination, song,
drum kit, user arpeggio pattern is protected.
• In Global mode, turn off write‐protect, and execute
the write or load procedure once again.
MIDI data receiving error
Meaning: While receiving MIDI System Exclusive
data, the format of the received data was invalid, for
example, because the size of the data was incorrect.
131