Raising The Machine Head - JUKI AMS-210EN/IP-420 Instruction Manual

3-10. Raising the machine head

WARNING :
When tilting or raising the sewing machine, be careful not to get your fingers caught between the
sewing machine and table. In addition, be sure to turn the power off before titling/raising the sew-
ing machine so as to protect against accidents resulting from unintentional starting.
4
6
A
5
3
[Area 2210]
6
1. Be sure to raise the machine head at the leveled place so as to prevent the sewing ma-
chine from falling.
2. When raising the sewing machine without removing throat plate auxiliary cover 6 , the
throat plate auxiliary cover interferes with the table, bend or breakage of the throat plate
auxiliary cover, tilt of the sewing machine, etc. will result.
3. When raising the machine head, move feeding frame 4 beforehand to the right-hand
side until it goes no further, and fix it with tape or the like. When the machine head is
raised in the state that moving or fixing is insufficient, breakage of X-move cover or
X-move rail will be caused. Besides, feeding frame 4 which is tilted to the left-hand side
by the self-weight interferes with the intermediate presser or the like and breakage of
the components will be caused.
[When area 1306 or 1510 is used]
To raise the sewing machine, carefully raise it until
bed support rubber 3 comes in contact with the
table while holding section A into which the sewing
machine bed is to be inserted by hand. For the S
type, remove chain 2 from manual pedal 1 first,
and perform the work.
2
1
– 9 –
1. Be sure to raise the machine head at
the leveled place so as to prevent the
sewing machine from falling.
2. When raising the machine head,
move feeding frame 4 beforehand
to the right-hand side until it goes
no further, and fix it with tape or
the like. When the machine head is
raised in the state that moving or
fixing is insufficient, breakage of
X-move cover or X-move rail will be
caused. Besides, feeding frame 4
which is tilted to the left-hand side
by the self-weight interferes with the
intermediate presser or the like and
breakage of the components will be
caused.
[When using area 2210]
1) Remove throat plate auxiliary cover
6 from the sewing machine.
2) Hold inserting section A of the ma-
chine bed by hand, and quietly raise
it until bed support rubber 3 comes
in contact with the table.
3) After returning the sewing machine
to its home position, refer to
Installing the throat plate auxilia-
ry cover" p.6, and install the throat
plate auxiliary cover.
"!-3-6.