Downloading New Software To The Phone - Polycom SoundStation IP 7000 Integration Manual

Integration Guide for the Polycom SoundStation IP 7000 Phone Connected to a Polycom HDX System in Unsupported VoIP Environments

Downloading New Software to the Phone

Note
Note
14
To use the provisioning server you just set up, you must change the default
network configuration parameters on the SoundPoint IP 7000 phone.
The phone must be connected to the local area network to download the new
software to the phone. Refer to
To download the new software to the SoundPoint IP 7000 phone:
1. Reboot the phone by pressing the reboot multiple key combination.
Press and hold the *, #, Volume-, and Volume+ keys simultaneously until
a confirmation tone is heard or for about three seconds.
2. While the phone is in its boot cycle, press the SETUP soft key.
3. Enter the administrative password, and then press the OK soft key.
The default password is 456.
The "Network Configuration" menu appears.
4. If DHCP is supported on the network:
Verify that the DHCP Client is enabled.
a
If it is not enabled, press the EDIT soft key, use the right arrow key to
select Enabled, and then press the OK soft key.
If DHCP is not supported by the network, you will need to set the phone IP address,
subnet mask, DNS, and gateway settings in step x. Contact your system
administrator for these values.
Using the down arrow key, scroll to DHCP Menu, then press the
b
SELECT soft key.
The "DHCP Menu" appears.
Scroll down to Boot Server, then press the EDIT soft key.
c
Using the right arrow key, select Static, and then press the OK soft
d
key.
Press the EXIT soft key.
e
The "Network Configuration" menu appears again.
5. If DHCP is not supported on the network:
Scroll up to Phone IP Addr, then press the EDIT soft key.
a
Enter the phone IP address, then press the OK soft key.
b
Scroll down to Subnet Mask, then press the EDIT soft key.
c
Enter the subnet mask, then press the OK soft key.
d
Connecting the Phone to the Network on page 4.