Installing The Seat; Assembling The Steeringwheel - Snapper SLT23460AWS SERIES 0 Safety Instructions & Operator's Manual

Installing the Seat
How to Install the Seat
1. Carefully remove the plastic bag from the seat. Use the
fasteners shown below to install the seat. The fasteners
are shown at full size.
Assembling the SteeringWheel
How to Assemble the Steering Wheel
Tools Required: 3/8" Socket Wrench
Attach the steering wheel as follows:
Figure 4: Seatparts
A - Wing bolt (Also see 'E' in Figure 3)
B- Washer (Also see 'F' in Figure 3)
NOTE:Fastenersmay be attachedto seat for shipping
purposes, if so remove fasteners before proceeding.
2. Align the holes in the seat hinge to the holes in the seat
(Figure 5). Fastenthe seat to the seat hinge with the
fasteners as shown.
3. Checkthe operating position of the seat. If the seat
needs to be adjusted, loosen the two wing bolts. Slide
the seat forward or backward along the seat adjusting
holes as shown. Tighten the wing bolts (A).
'\\\\
\
Figure 6: Steering wheel parts
A- Screw (Also see 'C' in Figure 3)
B- Washer (Also see 'D' in Figure 3)
1. Make sure the front wheels point forward.
2. Slide the bellows over the steering post
(Figure 7).
NOTE:Before attachment of the steering wheel, make
sure that the front wheels point forward and are
straight. For proper alignment of the steering wheel,
see Figure 7.
3. Slide the steering wheel onto the steering post.
4. Use the fasteners shown above to secure the steering
wheel. The fasteners are shown at full size. Tighten the
screw until snug and then add 1/4 turn. DO NOTover
tighten.
5. Attach the cover to the steering wheel.
6. Some models have an optionaldecal in the parts bag.
Attach the decal to the center of the steering wheel as
shown.
¢1D
3
Figure 5: Seat
A - Wing bolt
B - Washer
C - Seatadjusting hole
D - Seat hinge
E - Seat
English