Snapper SLT23460AWS SERIES 0 Safety Instructions & Operator's Manual page 17

\
Figure 13.Automatic drive disconnect
A - Automatic drive disconnect DRIVEposition
B - Automatic drive disconnect PUSH position
How to Set the Parking Brake
1. Completely push the brake pedal forward.
2. Lift the parking brake lever (Figure 14).
3. Removeyour foot from the brake pedal and then
releasethe parking brake lever. Make sure the parking
brake will hold the unit.
4. To releasethe parking brake, completely push the brake
pedal forward. The parking brake will automatically
release.
_ ARNING: Beforeyou leavethe operator's position,
move the speed control pedal to the neutral (N)
position. Set the parking brake. Move the blade
rotation control to the DISENGAGE position. Stop the
engine and remove the ignition key.
How to Changethe Cutting Height
To change the cutting height, raise or lower the deck ift lever
as follows:
1. Move the deck lift lever forward to lower the mower
housing and back to raise the mower deck (Figure 15).
2. When you ride on a sidewalk or road, move the deck lift
lever to the highest position and disengage the blades
(Figure 10).
Figure 15: Lift control
A - Deck rift lever
How to Stop the Unit
1. Slowly remove your foot from the speedcontrol pedal.
The speed control pedal will automatically return to the
NEUTRALposition and the unit will stop.
2. Move the blade rotation control to the DISENGAGE
position.
3. Set the parking brake.
,_ WARNING: Make sure the parking brake will hold the unit.
4. Move the throttle control to the SLOW position.
5. To stop the engine, turn the ignition key to the OFF
position. Remove the key.
¢D
0
Figure 14: Parking brake
A - Brakepedal
B - Parking brake lever
English
17