Snapper SLT23460AWS SERIES 0 Safety Instructions & Operator's Manual page 38

.m
How to Replacethe Fuse
If the fuse is blown, the engine will not start. The location of
the fuse is behind the panel between the engine and the
control console. Removethe fuse and replace with an
automotive fuse of equivalent rating (Figure 43).
Figure 43: Fuse location
A - Automotive fuse
How to Replacethe Light Bulb
1. Raise the tractor hood.
2. Turn the light socket until the tabs on the socket align
with the notches in the bezel (Figure 44). Remove the
light socket. Turn the light bulb and remove the bulb.
3. Install a new light bulb. Align the light socket with the
notches in the bezeland turn the light socket to lock in
position.
•_•_\\\\\\\\\\
\
How to Cleanthe Mower Deck
,_ WARNING: Before you clean the mower deck, stop
the engine and disconnect the wire to the spark plug.
Grass and other debris on top of the mower deck can keep
the belt from working correctly. For safety and correct
operation, frequently clean the top of the mower deck.
Remove grass and debris from around the pulleys and other
moving parts.
1. Cleanthe top of the mower deck.
2. After you cut the grass, clean the bottom of the mower
deck.
Figure 44: Light bulb replacement
A - Bezel
B - Light bulb
C - Light socket
38 www.snapper.com