Seat Adjustment Lever; Fuse; Tracking; Hydro Release Levers - Snapper SZ2042 Operator's Manual

CONTROLS

Seat Adjustment Lever

The seat can be adjusted lengthways. When
making adjustments, the lever below the right side
of the seat is pulled up, after which the seat can be
moved backward or forward.

Fuse

The 20 amp primary fuse is located on the left
hand side of the machine. It is accessed by tilting
the seat forward. The fuse is a flat pin type used in
automobiles.

Tracking

If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
1. Tracking adjustments are made using the
tracking bolts. The tracking bolts act as limiting
devices for the motion control levers when in
the full-forward position.
14
2. For preliminary tracking adjustment, move
unit to an open, unobstructed area such as an
empty parking lot or open field.
3. Back the tracking bolts out until flush with nut.
4. Test operate unit by driving it at full throttle and
the full forward position on both motion control
levers. Gradually turn in the tracking bolt on the
right hand side until the unit noticeably starts
drifting right.
5. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the left tracking bolt until unit
tracks straight.

Hydro Release Levers

Transaxle bypass linkages must be engaged when
pushing or pulling the mower. The release levers
are located on each side of the rear of the unit
below the rear engine plate. See Moving Machine
By Hand in the Operation section.
WARNING! Bypass linkages are located
close to the muffler. To prevent burns, the
engine should be shut off and allowed to cool
before the bypass linkage levers are handled.