Maintenancefreebattery - Snapper SLT23460AWS SERIES 0 Safety Instructions & Operator's Manual

.m
MaintenanceFreeBattery
How to Remove the Battery
To charge or clean the battery, remove the battery from the
unit as follows.
_ ARNING: To prevent sparks, disconnect the black
battery cable from the negative (-) terminal before
you disconnect the red cable.
_ ARNING: The battery contains sulfuric acid which is
harmful to the skin, eyes, and clothing. If the acid
gets on the body or clothing, wash with water.
1. Disconnect the black cable from the negative (-)
terminal (Figure 27).
2. Disconnect the red cable from the positive (+) terminal.
3. Lift the battery tray and the battery out of the unit.
How to Cleanthe Battery
1. Remove the battery.
2. Wash the battery with a solution of one gallon of water
and four tablespoons of baking soda (sodium
bicarbonate). Make sure the solution does not get into
the battery cells.
3. Cleanthe terminals and the ends of the cables with a
wire brush.
4. Install the battery.
5. To prevent corrosion, apply greaseto the battery
terminals.
How to Chargethe Battery
_il ARNING: When you charge the battery, do not
smoke. Keep the battery away from any sparks. The
fumes from the battery acid can cause an explosion.
1. Before you charge the battery, remove the battery.
2. To charge the battery, use a 12 volt battery charger.
Charge at a rate of 6 amperes for 1 hour.
3. Install the battery.
_il WARNING: To prevent sparks, fasten the red cable to
the positive (+) terminal before you connect the black
cable.
4. Fastenthe red cable and terminal cover (if equipped) to
the positive (+) terminal with the fasteners as shown.
5. Fastenthe black cable to the negative (-) terminal with
the fasteners as shown (Figure 27).
Figure 27: Battery
A - Carriagebolt
B - Hex nut
C - Black cable
D - Positive (+) terminal
E - Red cable
F- Battery
G - Battery tray
H - Terminal cover
28 www.snapper.com