Snapper SLT23460AWS SERIES 0 Safety Instructions & Operator's Manual page 41

Problem Correction
The grass does not discharge
correctly.
The mower housing does not
cut level.
The mower blades will not
rotate.
The unit will not move when
the brake is releasedand the
speed control pedal is
depressed.
The unit moves slower or
stops when the speed control
pedal is depressed.
Troubleshooting Chart Continued
.
2.
3.
4
5.
6.
1.
2.
3.
1.
2.
1.
2.
3.
Stop the engine. Cleanthe mower deck.
Raise the height of cut.
Replace or sharpen the blade(s).
Use a slower ground speed.
Move the throttle control to the FASTposition.
Replace the spring for the blade idler.
Checkthe air pressure in the tires.
Adjust the level of the mower deck.
Checkthe front axle. If the front axle does not freely pivot, loosen the axle bolt(s).
Checkthe mower drive belt(s). Make sure the belt(s) are installed correctly.
Replace the mower drive belt(s).
Releasethe automatic drive disconnect.
Checkthe motion drive belt. Make sure the belt is installed correctly.
Replace the motion drive belt.
1. Checkthe motion drive belt. Make sure the belt is installed correctly.
2. Replace the motion drive belt.
When the brake pedal is 1. Temporary belt noise does not change the operation of the unit. If belt noise is
released, belt noise can be continuous, check the routing of the belt. Make sure the belt is inside all belt guides.
heard.
The rear wheels spin over 1. Checkthe front axle. If the front axle does not freely pivot, loosen the axle bolt(s).
uneven terrain.
o
€_
o
o
English
41