Step 9 Wiring The Fireplace - Heat & Glo LifeStyle PIER-TVFL Installer's Manual

Step 9
Wiring the
Fireplace
CAUTION
THERMOCOUPLE
Figure 11. Standing Pilot Ignition Wiring Diagram
24
NOTE: Electrical wiring must be installed by a
licensed electrician.
Caution: Disconnect remote controls if you are
absent for extended time periods. This will
prevent accidental fireplace operation.
For Standing Pilot Ignition Wiring
Appliance Requirements
• This appliance DOES NOT require 110-120 VAC to
operate.
!
Optional Accessories
Optional remote control kits require that 110-120 VAC
be wired to the factory installed junction box before the
fireplace is permanently installed.
Wall Switch
Position the wall switch in the desired position on a
wall. Run a maximum of 25 feet (7.8 m) or less length
of 18 A.W.G. minimum wire and connect it to the
fireplace ON/OFF switch pigtails.
!
LABEL ALL WIRES PRIOR TO DISCONNECTION
WHEN SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION. VERIFY PROPER
OPERATION AFTER SERVICING.
GAS VALVE
WHITE T2
BLACK S1
WARNING
DO NOT CONNECT 110-120 V AC TO THE
GAS CONTROL V ALVE WALL SWITCH
OR THE APPLIANCE WILL
MALFUNCTION AND THE VALVE WILL
BE DESTROYED.
WARNING
DO NOT CONNECT 110-120 V AC TO THE
WALL SWITCH OR THE CONTROL
VALVE WILL BE DESTROYED.
BLACK L2
BLACK L1
HI-TEMP LIMIT SWITCH
ON
OFF
ON/OFF SWITCH
RED T1
THERMOPILE
REMOTE SWITCH
PIGTAIL
OPTIONAL WALL SWITCH,
THERMOSTAT OR REMOTE