Step 12 Before Lighting The Fireplace; Step 13 Lighting The Fireplace; After The Installation - Heat & Glo LifeStyle PIER-TVFL Installer's Manual

Table of Contents

Advertisement

Step 12
Before Lighting
the Fireplace
Step 13
Lighting the
Fireplace
After the
Installation
Before lighting the fireplace, be sure to do the
following:
Remove all paperwork and documents from
underneath the fireplace.
Review safety warnings and cautions
• Read the Safety and Warning Information
section at the beginning of this Installers Guide.
Double-check for gas leaks
• Before lighting the fireplace, double-check the unit
for possible gas leaks.
Double-check vent terminations and front
grilles for obstructions.
• Before lighting the fireplace, double-check the unit
for possible obstructions that could be blocking the
vent terminations or the front grilles.
Double-check for faulty components
• Any component that is found to be faulty MUST
BE replaced with an approved component. Tam-
pering with the fireplace components is DANGER-
OUS and voids all warranties.
A small amount of air will be in the gas supply lines.
When first lighting the fireplace, it will take a few
minutes for the lines to purge themselves of this air.
Once the purging is complete, the fireplace will light
and will operate normally.
Subsequent lightings of the fireplace will not require
this purging of air from the gas supply lines, unless
the gas valve has been turned to the OFF position,
in which case the air would have to be purged.
NOTE: The fireplace should be run 3 to 4 hours on the
initial start-up. Turn it off and let it cool completely.
Remove and clean the glass. Replace the glass and
run the fireplace for an additional 8 hours. This will help
to cure the products used in the paint and logs.
You've reviewed all safety warnings, you've checked
the fireplace for gas leaks, you know the vent system
is unobstructed, and you've checked for faulty
components. Now you're ready to light the fireplace.
WARNING: PLEASE REFER TO THE US-
!
ER'S MANUAL FOR ALL CAUTIONS,
SAFETY , AND W ARNING INFORMATION
PERTAINING TO THE LIGHTING AND OP-
ERATION OF THE FIREPLACE.
LEA VE THIS INSTALLA TION MANUAL WITH
THE APPLIANCE FOR FUTURE REFERENCE.
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

St-42tvfl

Table of Contents