Lanier LD235 Operating Instructions Manual page 105

Troubleshooting
Message
Cannot scan to send fax message
as scanner is in use for other
function.
Updating the destination
list... Please wait. Specified
destination(s) or sender's name
has been cleared.
5
Check whether there are any net-
work problems.
[13-10]
Check whether there are any net-
work problems.
[13-11]
96
Causes and solutions
The Copy or Document Server function is in
use. To cancel the job in process, do the follow-
ing, and then try faxing again.
Press [Exit], and then press the {Copy} or {Doc-
ument Server} key. Next press the {Clear/Stop}
key. When the message "
pressed. Stop copying?
"
[Stop] key was pressed. Stop
" appears, press [Stop].
storing?
The destination list is being updated from the
network using SmartDeviceMonitor for Ad-
min.
Depending on the number of destinations to
be updated, there may be some delay before
you can resume operation. Operation is not
possible while this message is displayed.
Wait until the message disappears. Do not
switch off the power while this message is dis-
played.
Wait until the message disappears. Do not
switch off the power while this message is dis-
played.
The alias telephone number you entered is al-
ready registered on the gatekeeper by another
device.
• Check that the alias telephone number is
correctly programmed in IP-Fax Settings
under Facsimile Features. You can also use
the Web Image Monitor for confirmation.
See the Web Image Monitor's Help.
Reference
p.151 "Configuring the H.323 gate-
keeper", Facsimile Reference <Advanced
Features>
• Consult your network administrator.
Cannot access gatekeeper.
• Check that the gatekeeper address is cor-
rectly programmed in IP-Fax Settings un-
der Facsimile Features. You can also use
the Web Image Monitor for confirmation.
See the Web Image Monitor's Help.
Reference
p.151 "Configuring the H.323 gate-
keeper", Facsimile Reference <Advanced
Features>
• Consult your network administrator.
[Stop] key was
" or