Table of Contents
Advertisement
Adjusting fastening torque
The fastening torque can be adjusted in six
stages by turning the adjusting ring so that
the pointer on the adjusting ring points to
a number on the tool body. The fastening
torque is minimum when the pointer points
to the number 1 and maximum when it
points
to the -,_,= marking.
The clutch
will slip at varying torque levels when the
pointer
is set at the numbers 1 to 5. The
clutch is designed not to slip at the
-,_=
marking.
Before actual operation,
drive a trial screw
into your material
or a piece of duplicate
material to determine which torque level is
required for a particular application.
Adjusting
ring
Pointer
!
NOTE
:
The
adjusting
ring cannot
be locked
with
the pointer
positioned
half-way
between
the
numbers.
Screwdriving operation
Place the point
of the driver bit
in the
screw head and apply pressure to the tool.
Start the tool slowly and then increase the
speed gradually. Releasethe trigger as soon
as the clutch cuts in.
Advertisement
Table of Contents
