Antennancr Connections - Sears LXI series 580.53425390 Owner's Manual

ANTENNANCR CONNECTIONS
ANTENNAS WITH ONE LEAD (Combined VHF-UHF)
VCR
%__
75-ohm Coaxial (round) Cable
300-ohm Twin-lead Flat Cable
DOff
@'@ OI]O_]Ql]OI]O
_'_ IOOl]_OUo_OL iDI]D
,, F---ql
To "IN FROM ANT"
..... Adaptor (3_-ohm to 7S-ohm)(notsupplied)
7
@
1. Disconnect the antenna leads from the rear of the
"iV receiver.
2. Identify the type of cable from your antenna. If it is
a round cable as illustrated, it is a 75-ohm coaxial
antenna cable. This cable will connect directly to
the connector marked "IN FROM ANT" on your
VCR.
If your antenna lead wire is a flat type antenna
cable, connect it to the Antenna Adaptor (300-ohm
to 75-ohm) (not supplied) and slip the Adaptor onto
the "IN FROM ANT" terminal. The Adaptor does not
screw onto the VCR, it just slips over the connector.
ANTENNA WITH SEPARATE VHF-UHF LEADS
I
1. Disconnect the UHF/VHF twin leads on your
television.
2. Locate Antenna Mixer(VHF/UHF 300-ohm to 75-
ohm) (not supplied).
3. Connect the VHF Twin-lead Cable to the "VHF"
terminals on the Antenna Mixer.
4. Connect the UHF Twin-lead Cable to the "UHF"
terminals on the Antenna Mixer.
5. Slip the Antenna Mixer onto the "IN FROM ANT"
terminal.