Table of Contents
Advertisement
SET YOUR TELEVISION
TO THE VCR CHANNEL
,
Set your TV to Channel 3 unless Channel
3 is
one of the TV stations in your area. If Channel 3
is used in your area, set your "IV to Channel 4.
The RF Channel Select Switch is located on the
Rear Control Panel. Slide the switch of CH3 or
CH4 to match the channel selector on your -IV.
This is the VCR channel on your television
set.
Your television
receiver
must be tuned to this
channel any time a video cassette is played back
on the VCR.
E
uur-----_l
Ig_J
"RF Channel" Select Switch
.
Plug the VCR power cord into a 120V electrical
outlet and press "POWER"
ON/OFF button on,
and the "POWER" and "VCR" lights will come on.
The clock will show" - • - - "
(See "Clock Setting" Instructions on page 22.)
NOTE:
When
the
power
is turned
on, the
"VCR/TV" selector is switched to the VCR mode
automatically.
C
====.==_
"POWER" ON/OFF Button
3. Select
an active TV channel
by pressing
the
Channel Select button ( •
or A) on the remote
control aiming at the front panel of the VCR. The
picture
from
that
channel
should
now
be
displayed on your television.
NOTES:
• If the range is short, try new batteries.
• An object between the VCR and remote control
may block the invisible light beam and operation
will not be possible.
"CHANNEL"
Select Button (V or A)
C_t_NNEL_
TRACKING
pLAy
MENU
_,_
DISPL_*y
®®®
® ®'®
®®®
4, Fine tune the television for best picture.
NOTE: If both Channel 3 and Channel 4 are in
use in your area, select the one which does not
interfere with the playback picture.
SPECIAL NOTE:
Certain
television receivers
with "ELECTRONIC
TUNERS" may require special procedures to tune
Channel 3 or 4. These receivers may not tune to the
VCR channel (3 or 4) because there isn't an active
iV station on these channels.
In these cases,
press VCR "POWER"
ON/OFF
buton on. Make sure that the "VCR" indication in the
display panel is on. If the indication
is off, press
"VCR/TV" selector on the remote control to turn the
"VCR" indication on. Tune VCR tuner to an active
channel. The television receiver will now tune in to
the VCR channel
(Channel
3 or 4). For more
detailed
instructions,
consult
your
TV owners
manual.
HOW TO INSTALL
THE BATTERIES
IN THE
REMOTE CONTROL
NOTES:
1. Be sure to install two
"AAA" size batteries (not
supplied) before use.
2. Be aware of the polarity
(Remove the protect compartment cover comple-
tely.)
Advertisement
Table of Contents
