Table of Contents
Advertisement
Set the hour by pressing two number buttons on
the remote control and two more for the minute
(for example,
0 2 15 for 2:15).
The display
prompts you to select AM or PM.
CLOCK SET
AT}_.I - 02:15_'L_/-
TO END PUSH MENU
i_ Press "1" for AM or "2" for PM (for example, 2 for
PM).
The display flashes and prompts you to set the
date.
CLOCK SET
TIME 02:15 PM
MONTH/DAY/YEAR
DATE -_-_'--/-
...
TO END PUSH MENU
Set the date by pressing six digits in order of
month, day and year (for example 09 01 93 for
September
1, 1993). The day of the week will
appear when you have entered all six digits for
the date.
NOTE:
Always
press
"0" before
single-digit
months and days.
• The VCR will not accept illogical time or date
entries (13th month for example).
• Now the display
on the VCR will show the
correct time.
CLOCK SET
TIME 02:15 PM
MONTH/DAY/YEAR
DATE
09/01/93
WED
TO END PUSH MENU
{) Press "MENU" button. The display resumes the
"original menu".
PUSH SELECTION NUMBER
1 CLOCK SET
2 NORMAL PROGRAM
3 DAILY PROGRAM
4 WEEKLY PROGRAM
5 PROGRAM REVIEW
6 SET UP
TO END PUSH MENU
i_) Press "MENU" button once again to return to the TV screen.
CLOCK SETTING NOTES:
1. The clock must be set to the correct time before programming the timer for unattended recording.
2. When moving the VCR, if the power cord is reconnected within a few seconds (about 3 seconds), there is no
need to reset the clock.
3. If a power failure lasts more than a few seconds, or if the power cord is disconnected for longer than a few
seconds, the" - • - -" display will appear when power is restored and the clock needs to be reset.
Advertisement
Table of Contents
