Antenna/Vcr Connections - Sears LXI series 580.55144490 Owner's Manual

ANTENNANCR CONNECTIONS
ANTENNAS WITH ONE LEAD (Combined VHF-UHF)
VHF/UHF Antenna
!
I
° ,
_c. _ ooooDoooo L__J---r3
nonooo u-u r---__ I el
o Ilnaaonoonaoa t I' '1 I
_'- _ ! ! ilJ
To "IN FROM ANT" 75-ohm Coaxial (round) Cable
300-ohm Twin-lead Flat Cable _ I
"_L.-_f Antenna Adaptor (300-ohm to 75-ohm) (not supplied)
1. Disconnect the antenna leads from the rear of the
"FV receiver.
2. Identify the type of cable from your antenna. If it is
a round cable as illustrated, it is a 75-ohm coaxial
antenna cable. This cable will connect directly to
the connector marked "IN FROM ANT" on your
VCR.
If your antenna lead wire is a flat type antenna
cable, connect it to the Antenna Adaptor (300-ohm
to 75-ohm) (not supplied) and slip the Adaptor onto
the "IN FROM ANT" terminal. The Adaptor does not
screw onto the VCR, it just slips over the connector.
ANTENNA WITH SEPARATE VHF-UHF LEADS
VHF Antenna UHF Antenna
I
300-ohm Twin-lead
Flat Cable
VCR
_ IIIIIIIII _ =_
nnnooo_nn / _
IIlOOOOOIII / k-_-_
To "IN FROM ANT"
Antenna Mixer (VHF/UHF 300-ohm to
75-ohm) (not supplied)
1. Disconnect the UHF/VHF twin leads on your
television.
2. Locate Antenna Mixer(VHF/UHF 300-ohm to 75-
ohm) (not supplied).
3. Connect the VHF Twin-lead Cable to the "VHF"
terminals on the Antenna Mixer.
4. Connect the UHF Twin-lead Cable to the "UHF"
terminals on the Antenna Mixer.
5. Slip the Antenna Mixer onto the "IN FROM ANT"
terminal.
-6-