GE CS980 Owner's Manual page 49

GEAppliances.com
Possible Causes What To Do
"F--" and a number or You have a function error code. , Touch the CLEAR/OFFpad. Allow the oven to cool for
letter flash in the display one hour. Putthe oven back into operation.
If the function code repeats. , Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error code
repeats, call for service.
Probe appears m This is reminding you to enter . Enter a probe temperature.
the display a probe temperature after
plugging in the probe.
Display goes blank A fuse in your home may be • Replacethe fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the , See the Specialfeatures ofyour upper oven control section.
black-out mode.
Display flashes Power failure. . Reset the clock.
mo get the Oven control pads were . The BAKE and BROIL HI/LO pads must be touched at
display to show "SF" not pressed properly, the same time and held for 3 seconds.
Power outage, Power outage or surge. . Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
saB " i_ st • i_ urnmg or oily This is normal in a new oven . To speed the process, set a self-dean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent upper oven section.
Strong odor An odor from the insulation . This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
LOC appears in
the display
Fan noise
The Range Lockout feature
is activated.
, Be sure the surface unit controls are turned OFF.
Turn this feature off to use the range.
See the Range Lockout section.
The convection
fan may turn
on and off automatically.
, This is normal. To maximize cooking evenness,
the fan is designed to operate in both directions
with a pause in between.
Convection fan Preheat temperature . Fanwill start automatically once the preheat
not working not reached, temperature is reached.
Drawer does not slide The drawer is out of alignment. • Fullyextend the drawer and push it all the way in,
smoothly or drags See the Care and cleaning of the range section.
Drawer is overloaded or load . Reduce weight. Redistribute drawer contents.
is unbalanced.
Lower oven drawer A fuse in your home may be • Replace the fuse or reset the circuit breaker.
will not work blown or the circuit breaker tripped.
The upper oven is self-cleaning. • Wait for the self-clean cycle to finish and the oven
to cool.
Controls improperly set. . See the Lower oven drawer section.
Excessivecondensation Liquid in drawer. • Removeliquid.
in the drawer
Uncovered foods. . Cover food with lid or aluminum foil.
Temperature setting too high. . Reducetemperature setting.
Food dries out in the Moisture escaping. • Cover food with lid or aluminum foil.
lower oven drawer
Oven drawer not fully closed. . Pushdrawer in until latch engages.
49