GE CS980 Owner's Manual page 37

Cleaning the glass cooktop. GEAppliances.c
I
Clean your cooktop
after
each spill. Use CERAHA
BRYTE_ Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuse CERAMABRYTE ® Ceramic Cooktop
Cleaner on the glass cooktop. Other creams
may not be as effective.
To maintain and protect the surface of your
glass cooktop, follow these steps:
%
Before using the cooktop for the first time,
clean it with CERAMABRYTE ® Ceramic
Cooktop Cleaner.This helps protect the
top and makes cleanup easier.
r_ Daily use of CERAMABRY1-E ®Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
few drops of CERAIVlA BRWE ®Ceramic
Cooktop Cleaner directly to the cooktop.
[] Use a paper towel or CERAMABRYTE ®
Cleaning Pad for Ceramic Cooktops to
clean the entire cooktop surface.
r_ use a dry cloth or paper towel to
remove all cleaning residue. No need to
rinse.
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
[] Shakethe cleaning cream well. Apply a
Burned-On Residue
NOTE: DAMAGEto your glass surface may
occur if you use scrub pads other than those
recommended.
Use a CERAMABRYTE _ Cleaning
Pad for Ceramic Cooktops.
I-f] Allow the cooktop to cool.
[] Spread a few drops of CERAIVlA BRY1-E A:
Ceramic Cooktop Cleaner on the entire
burned residue area.
%
Using the included CERAMABRYTE , _
Cleaning Pad for Ceramic Cooktops, rub
the residue area, applying pressure as
needed.
%
@
If any residue remains, repeat
the steps listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE ' _
Ceramic Cooktop Cleaner and a paper
towel.
The CERAMA BRYTE _-Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under "To
Order Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
%
Allow the cooktop to cool.
Use a single-edge razor blade scraper
at approximately a 45 ° angle against
the glass surface and scrape the soil. It
will be necessary to apply pressure to
the razor scraper in order to remove
the residue.
@
After scraping with the razor scraper,
spread a few drops of CERAMA BRYTE _
Ceramic Cooktop Cleaner on the entire
burned residue area. Use the CERAMA
BRYTE ' _ Cleaning Pad to remove any
remaining residue.
%
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE ' _
Ceramic Cooktop Cleaner and a paper
towel.
37