Table of Contents
Advertisement
8.
Secure plastic flex tubing to outer driveshaft tube using plastic clamps (I)
provided. Do not fully tighten plastic clamps until throttle cable and stop
switch wires are connected and all final throttle cable and handlebar ad-
justments are completed.
9.
Handlebar Adjustments:
a. Loosen 2 lower cap retaining screws (A) to adjust handlebar location
on outer drive shaft tube.
b. Loosen 4 handlebar clamp screws to adjust handgrip position.
Access handlebar clamp screws through 4 holes (J) in bottom of
handlebar mounting bracket.
c. Tighten all clamp and retaining screws securely after making final
adjustments. (See page 10.)
Throttle Linkage and Ignition Leads
1.
Thread throttle cable adjuster (A) into throttle cable bracket (B), and install
wire end into large carburetor swivel hole (C). Check throttle for freedom
of movement and that wide open throttle/low idle extremes are adjusted
properly. Turn the cable adjuster in or out to make adjustments. After
adjusting, hold the cable adjuster (A), and tighten the cable adjuster nut (D)
against the cable bracket (B) to lock the setting.
2.
Connect 2 ignition stop leads from throttle cable tubing to ignition leads on
engine (E) and grounding screw (F).
3.
Reinstall the air cleaner cover.
I
J
E
A
E
J
B
A
C
D
F
I
E
J
J
E
E
7
Advertisement
Table of Contents
