Factory Test Print Mode - SATO CG4 Series Operator's Manual

Section 3: Operation and Configuration

3.4 FACTORY TEST PRINT MODE

This mode produces test labels for diagnostic purposes.
Preparation:
Make sure the media or ribbon (if required) are properly loaded in the printer.
Procedures
While pressing
FEED/LINE button, press
and release POWER
button. Keep holding
FEED/LINE button.
Release FEED/LINE
button when ERROR
indicator changes to red
light and two short beeps
sound are heard.
(The printer will cyclically
advance to next mode as
long as the FEED/LINE
button is held down.)
Press FEED/LINE button
to start test printing.
Press FEED/LINE button
to pause the test printing.
Press again to resume.
Notes:
• If you missed the chance to release the FEED/LINE button in step 2 above, just keep holding the FEED/
LINE button and wait for the next cycle.
• If you released the FEED/LINE button at the wrong ON LINE (POWER) or ERROR indicators, just turn off
the power and restart the procedure.
• The printer will continuously print the Factory test labels until the FEED/LINE button is pressed. The print-
ing is paused and will resume printing if the FEED/LINE button is press again.
To terminate the Factory Test Print mode
First, ensure that you have pressed the FEED/LINE button to pause the test printing, then press POWER to
turn off the printer.
Page 3-8
Printer status
Printer start-up
User Test Print Mode.
Factory Test Print
Mode.
FEED/LINE
released
Factory Test Print
mode is activated and
then paused.
FactoryTest Print start
and print continuously.
Factory Test Print
paused.
ON LINE (POWER) ERROR
indicator indicator
Red light
Off
Green light Off
Off Red light
Off
Blinking green light
Off
Green light
Off
Blinking green light
CG4 Series Operator Manual
Buzzer
One short
beep
Two short
beeps