3.5 OPERATION SETTING MODE
The operation setting mode enables further selection of the functions of the printer. These are:
•
Program download mode
•
Font download mode
•
Default setting mode
•
HEX dump mode
•
USB interface
•
RS-232C/ IEEE 1284/ LAN interface
•
Keypad selection
•
Scanner/ Smart keyboard selection
Selection of the above operation setting modes are as shown below.
Procedures
While pressing
FEED/LINE button, press
and release POWER
button. Keep holding
FEED/LINE button.
Release FEED/LINE
button when ON LINE
(POWER) indicator
changes to blinking green
light and three short
beeps sound are heard.
(The printer will cyclically
advance to next mode as
long as the FEED/LINE
button is held down.)
CG4 Series Operator Manual
Printer status
Printer start-up
User Test Print Mode.
Factory Test Print Mode
Operation Setting Mode
Section 3: Operation and Configuration
ON LINE (POWER)
ERROR
indicator
indicator
Off
Red light
Green light
Off
Red light
Off
Blinking green light
Off
To be continued on the next page.
Buzzer
One short
beep
Two short
beeps
Three
short
beeps
Page 3-11