Loading Labels - SATO CG4 Series Operator's Manual

2.3 LOADING LABELS

2.3.1 Loading Roll media
With the power supply off, pull the cover open/close
1.
on both sides of the printer toward you to
latches
1
unlock the top cover, and then open the top cover
Note:
Make sure that the cover rests firmly so that it will not fall
forward and injure your hands.
While holding the media guide slide lever, adjust the
2.
width of the media holder
Load the media onto the media holder.
3.
After pulling out the media, pass the media through the
4.
media guides and place the leading edge of the media
on top of the platen roller.
Note:
Make sure the printed side of the media is facing
upwards.
CG4 Series Operator Manual
to match the media size.
1
.
2
1
Media guide
slide lever
Media guides
Printed side should face
upwards
Section 2: Installation
1
2
1
Page 2-3