Types Of Test Print; Explanation Of The Contents Of Each Piece Of Factory Test Print 1 - SATO HR2 Series Operator's Manual

3.13 TEST PRINT MODE (Cont'd)

3.13.1 Types of Test Print

The following test print types are available.
1. Factory Test Print 1
2. Factory Test Print 2
3. Configuration Printout
4. Print of Supported Barcodes
5. Print of Head Check
6. Print Head and Sensor Check
7. Memory state
8. Print of Supported Fonts
9. Print Test Pattern for Small Pitch Label

3.13.2 Explanation of the contents of each piece of Factory Test Print 1

Factory test print enables to print out the printer setting.
Printed contents are subject to change without notice and the value depends on individual settings.
The printer setting will be printed on three pages.
1)First page--
Item name (Print)
Model Name
Firm Version(Font
Ver)
Firm Date
S/N
CONT S/N
HR2 Series Operator Manual
Item name
Model Name Printing the printer's model name.
Firmware version 41.xx.xx.xx(xx.xx(R))
and font version Font version is Kanji font version shown in the table.
Font version is not included in CODE39 barcode.
Firmware creation YY.MM.DD
date (The last two digits of the year, month, and date)
Printer's serial No. xxxxxxxx
CONT PCB's serial xxxxxxxx
No.
Section 3: Operation and Configuration
Description
Head dot density
12 dot/mm
24 dot/mm
Model
HR212
HR224
Page 3-39