SATO CG4 Series Operator's Manual page 75

7.2 RS232C SERIAL INTERFACE (cont'd)
Function descriptions
Function
Baud rate setting
Data bit length
Parity setting
Stop bit setting
Protocol setting
Synchro system
Maximum receive
buffer capacity
Code
Transmission form
Signal level
Interface type
CG4 Series Operator Manual
Description
Select the data rate (bps) for the RS232 port.
Sets the printer to receive either 7 or 8 bits of data for each byte transmitted.
Selects the type of parity used for error detection.
Selects the number of stop bits to end each byte transmission.
Selects the flow control and status reporting protocols
Asynchronous method
1MB
0MB
Buffer near full
occurred
Buffer near full
released
ASCII (7 bits), Graphic (8 bits)
Start
b1 b2 b3
[Note] If using 7 bits, b8 will be omitted.
High level : +5 to +12V
Low level : -5 to -12V
Use Printer configuration tool or <DI> command.
<DI>a
Parameter Item
Interface
a
selection
Section 7: Interface Specifications
b4 b5 b6 b7 b8
Value
0
1
2
3 Scanner/ Smart keyboard
1MB
Remaining 0.25MB
Remaining 0.5MB
Stop
Description
USB
RS-232C
Keypad
Page 7-3