SATO CG4 Series Operator's Manual page 22

Section 2: Installation
2.4 LOADING THE CARBON RIBBON (FOR CG408TT, CG412TT ONLY) (cont'd)
Open the carbon ribbon package, and then load the
3.
ribbon in the ribbon supply unit.
With the ribbon winding in clockwise direction, push in
the ribbon roll to the right side of the ribbon supply unit
. Then fix the other side of the ribbon roll to the left of
1
the ribbon supply unit
core snaps on the protrusion of the left ribbon supply
unit.
Note:
Use only genuine SATO carbon ribbons for maximum
print quality and printer durability.
Mount the empty ribbon core on the ribbon wind-up
4.
unit the same manner as in step 3 above.
When loading the carbon ribbon for the first time, use the
empty ribbon core supplied with the printer. However,
the subsequent ribbon core can be obtained from the
last used up ribbon roll.
Page 2-8
. Turn the ribbon roll until the
2
2
groove
protrusion
2
groove
protrusion
CG4 Series Operator Manual
1
1