Table of Contents
Advertisement
Installation
3.8
Changing the OSD
Language
3.9
Adjusting the Picture
Orientation
3.10
Primary Lens
Adjustments
Focus
Zoom
Vertical and Horizontal
Lens Shift
The RS-1100 OSD language is initially set to English, but can also display the menus in
French, Spanish, Italian or German. To change the OSD language:
1. Press MENU.
2. Select Installation from the Main Menu and press ENTER.
3. Select Language from the Installation Menu and press ENTER.
4. Press
or
to highlight the desired language. (The change takes effect
immediately.)
By default, the RS-1100 is configured for a "floor/front" installation, in which the projector
is installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. Press MENU on the remote control.
2. Select Installation from the Main Menu and press ENTER.
3. Select Picture Orientation from the Installation Menu and press ENTER.
4. Choose Floor Rear, Ceiling Front or Ceiling Rear to match the installation method.
The RS-1100 gives you a great deal of control over the
picture size, position and focus. To access the motorized
lens controls, use the FOCUS, ZOOM and LENS buttons
on the remote control.
To focus the projected image, press the FOCUS button, then use the left- and right-arrow
buttons to adjust the focus.
To make the picture smaller (zoom out), press the ZOOM button, then use the left-arrow
(
) button.
To enlarge the picture (zoom in), press the ZOOM button, then use the right-arrow (
button.
Vertical Lens Shift: To shift the projected image vertically, press the LENS button, then
use the up and/or down-arrow (
Horizontal Lens Shift (RS-1100 Ultra Only): To shift the projected image horizontally,
press the LENS button, then use the right and/or left-arrow buttons.
,
) buttons.
32
Runco RS-1100 Series Owner's Operating Manual
FOCUS
ZOOM
LENS
FOCUS
ZOOM
LENS
)
Advertisement
Table of Contents
Troubleshooting
