Lens Focus Adjustment; Adjusting The Picture Orientation - Runco LightStyle LS-100d Installation & Operation Manual

The LS-100d lens focus controls are located
beneath a hinged door on the top of the
projector. To access them, press down on the
door edge closest to the mirror and open the
door.
Use the Coarse Focus Adjust dial to adjust the
focal length in large increments. Use the Fine
Focus Adjust dial to adjust the focal length in
small increments.
The two focus controls are interactive, so you may need to adjust
Note
each one multiple times to produce a fully-focused image.
By default, the LS-100d is configured for a "floor/front" installation, in which the projector
is installed upright and in front of the screen. If it is mounted on a ceiling, you must change
the picture orientation. To do this:
1. On the DHD Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
You must enter a passcode to access the Service menu.
Note
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Installation.
5. Select Orientation, then choose Ceiling/Front, to match the installation method. Or,
for front-projection installations, use the Auto setting to have the projector
automatically determine the orientation (floor or ceiling) using an internal sensor.
Lightstyle™ Series LS-100d Installation/Operation Manual
Press Here
to Open Door
Coarse
Focus Adjust
Fine
Focus Adjust
31
Installation
3.7
Lens Focus
Adjustment
3.8
Adjusting the Picture
Orientation